Paver Repair & Re-Sanding — Walled Lake, Michigan
Paver Repair & Re-Sanding in Walled Lake
On Walled Lake's compact cottage-era streets, lots step down toward the water, and a walk or patio on that slope sits in the path of rain headed for the lake. That runoff, along with wind off the open water, can carry joint sand away, and pavers with empty joints lose their grip on one another.
Free written estimate within 24 hours Zero travel fees
Paver walkwayOvergrown turf and soil washed off a brick paver walk
- 4.9 from 177 Google reviews
- 1,200+ projects since June 2022
- $2M insured, plus workers' comp
- 24h to a free, written, line-item quote
Paver repair & re-sanding in Walled Lake carries no travel fee, and every job gets a written, line-by-line quote within 24 hours.
| Service | Paver Repair & Re-Sanding |
|---|---|
| Area | Walled Lake, Oakland County, Michigan |
| Price | Quoted per job, from photos or in person |
| Travel fee | None |
| Written quote | Within 24 hours |
| Call or text | (586) 284-3810 |
In Walled Lake
Walled Lake wraps the east end of its namesake all-sports lake. Mercer Beach is the public front door to the water, the historic downtown sits on Pontiac Trail, and the cottage-era streets step down toward the shore, where seawalls and lakeside patios meet the lake. Rain from the roof and the yard runs downhill across whatever is paved on the way.
Joint sand is not filler. The Concrete Masonry and Hardscapes Association (CMHA) describes it as the part of the system that passes load from one paver to the next, essential to interlock and stiffness. As joints empty and widen, the paver layer gets less stiff and pushes more stress onto the layers below. CMHA lists concentrated runoff, driving wind and hard cleaning among the ways joints lose sand, and points to downspouts and eave drip lines as places where water gathers.
That is why the slope matters. CMHA treats joint stabilization as optional on most paving but recommends it on slopes over 7 percent, meaning more than 7 inches of fall for every 100 inches of run, and where water or cleaning is hard on the joints: regular heavy rain, downspouts and eave drip lines, or frequent hard cleaning. A walk stepping down to a seawall can meet several of those at once. Through paver repair we reset any low spots, then re-sand those joints with polymeric sand at full depth.
How we work
Re-Sanding From the Bottom of the Slope Up
Repairs come before sand, the order SEK-Surebond's preparation guidance sets. If the foot of a sloped walk has sunk where water collects, that section is lifted, its base built back with compacted base material, and the pavers reset on fresh bedding sand.
The old joint sand comes out to at least 1½ inches without digging into the bedding. Then the surface has to dry completely, tops, sides and joints, under a forecast that holds: no rain for 12 hours by SEK-Surebond's rule, temperatures above freezing for 48, and sprinklers off. Polymeric sand is swept in, plate-compacted, topped up and compacted again, then finished about 1/8 inch below the paver tops or at the bottom of the chamfer, because a joint filled flush can wear out early.
Every bit of dust is blown off the faces before water touches them. Activation starts at the low point of the slope and works uphill in a light shower, and a probe confirms the binder set below the surface.
Re-Sanding Mistakes on a Lot That Slopes to the Lake
Skimming polymeric sand over the old sand in a half-empty joint is a quick fix that doesn't hold. Alliance Gator says polymeric over a partly filled joint peels and flakes, CMHA doesn't recommend polymeric sand for topping up at all, and the makers want one material at full depth.
Watering from the top of the slope or flooding the joints with a hose works against the instructions: Alliance Gator and Techniseal both start at the low point, and Techniseal warns against overwatering. A downspout left emptying onto the patio keeps working on the joints, too.
When to Book Paver Repair & Re-Sanding in Walled Lake
Re-sanding waits on dry pavers and a 48-hour window above freezing, so the schedule follows the forecast; the National Weather Service office in Detroit puts the end of Southeast Michigan's growing season in October. CMHA suggests a look each spring during a rain, when the water shows where it runs, and again in late summer. Before snow, reset pavers sitting more than 1/8 inch high, shovel diagonally to the pattern, and choose a deicer from our post on ice melt that is safe for pavers.
Questions, answered
Paver Repair & Re-Sanding in Walled Lake: FAQs
Sand keeps washing out of the joints by our downspout. Why there?
A downspout or roof edge concentrates water onto a small patch of pavers, and CMHA names concentrated flow among the causes of joint sand loss. It recommends stabilized sand in those spots, so we clear the joints to 1½ inches and refill them with polymeric sand. Pointing the downspout elsewhere would take water off the patch, but that is drainage work, which we don't do.
Can we just sweep more sand into the joints ourselves?
If the joints hold plain sand, yes. CMHA's maintenance guide tops them up with dry masonry sand, swept in on a dry day, once the sand drops more than 1/2 inch below the paver tops. Don't top them up with polymeric sand: CMHA doesn't recommend it for that, and over old sand it peels and flakes. Polymeric belongs in joints cleared to at least 1½ inches.
There's a white film on the pavers after the joints were watered in. What happened?
Two different residues look alike. One is efflorescence, which Alliance Gator says the activation water itself can bring to the surface. The other is polymeric haze, left by dust on the faces or sand stuck to damp pavers; it comes off easily while still moist, but once cured it takes hot water and scrubbing. Our guide on removing efflorescence from pavers covers the first.
How is paver repair priced in Walled Lake?
Repair has no published price, since a joint re-sand and a reset at the foot of a slope are different jobs. Send photos of the area, ideally one taken during rain, or ask for a visit, and a written estimate follows within 24 hours. Walled Lake is about 46 minutes from our Clinton Township shop, with no travel fee, the same as Wixom or Commerce Township.
More in Walled Lake
Service overviews
What Neighbors Say About Our Work
Live from our Google Business Profile — 4.9 stars across 177+ reviews, nothing filtered out.
Free estimate
Book Paver Repair & Re-Sanding in Walled Lake
Send photos of the low spot, the loose edge or the empty joints, or have us look in person. Every repair gets a written estimate within 24 hours.
- Written quoteWithin 24 hours
- Shop21366 Hall Rd,
Clinton Township - Insurance$2M + workers' comp
